Hongxing, wooden pellet mill and Biological granulator manufacturer, will tell you the accurate operation and maintenance of granulator in this article.
1. Accurate device or changing the ring die and press roller The new model is equipped with a new roller, and the old one is equipped with the old roller, so that the external appearance of the ring die and the press roller is close to the external shape of the imitation, and the gap between the ring die and the press roller Mostly similar. In this way, all ring molds are very evenly loaded and discharged, which can improve the effectiveness of consumption.
2. The team maintenance and granulation machine should do a pre-class review every shift, review each transmission component, instrument, and valve, and add smooth oil based on lithium to smooth oil and iron scraps on the iron.
3. Adjustment of Ring Die and Roller Gap With regard to the adjustment of the new ring die and nip roller gap, the ring die and the press roller should have a slight contact with the highest point. If the adjustment is performed in the task status, the pressure of the ring die and the press roller can be properly increased, but it must be sufficient. The gap between the ring die and the press roller is too large, and the press roller cannot rotate, forming a jamming machine. If the clearance between the ring die and the press roller is too small, wear of the ring die and the press roller will increase, and the load will increase, and the major damage to the ring die and the press roller will be formed. To review the gap between the ring mold and the press roll in a timely manner, review it at least once every four task hours. When adjusting each press roll, pay attention to the adjustment direction of each press roll, and the granulator should make the moment of each press roll related to the granulator shaft equal to zero, so that the granulator is protected from the asymmetrical force.