Distributor of roller shells with high production standards

Distributor of roller shells with high production standards.

The biomass pellet machine is the granulation equipment of the biomass pellet machine, the compressor of the biomass granulation equipment, the bearing and lubrication system of the granulation equipment, and its size is derived from axial cracks or angular cracks.

The main drive of the biomass pellet machine adopts high-precision gear transmission, and the ring mold adopts a quick release clamp type. The transmission part of the entire machine adopts high-quality bearings from Switzerland and Japan to ensure efficient, stable, and low noise transmission. The ring mold adopts a quick release clamp type, and the feeding adopts frequency conversion speed regulation to ensure uniform feeding. The door cover is equipped with a compensation type snake spring coupling of a certain international advanced level, which has a novel, compact, safe, and low noise structure Low fault performance.

Biomass pellet machines can be divided into flat mold pellet machines and circular mold pellet machines, each of which has one type. The ring mold particle machine and pressure roller are forged and precision machined with alloy steel, which has the characteristics of reasonable design, unique structure, efficient energy reduction, and long service life. It is a kind of equipment that compresses organic materials such as biomass straw, pasture, bark, etc. into biomass Pellet fuel, which solves the key problem of large-scale utilization of biomass.

Correctly adjust the working gap between the ring mold and the pressure roller to be between 01~03mm (after the new granulator is turned on, the pressure roller is in a "quasi rotating" state driven by the ring mold);

The new ring mold should be equipped with a new pressure roller for use, and the pressure roller must be loosened before and tightened after fitting with the ring mold. When sharp corners appear on both sides of the pressure roll, the flange of the pressure roll shall be polished with a hand Bench grinder in time to facilitate the good cooperation between the pressure roll and the ring mold;

Before the raw material granulator, it must undergo initial cleaning and magnetic separation treatment to reduce iron pressure into the mold hole. And regularly check the mold holes to see if there is any mold blockage. Timely punch or drill out blocked mold holes;

The plastic deformation of the guide cone hole of the ring mold causes shrinkage, which should be repaired. When repairing, it should be noted that the lowest point on the inner surface of the ring mold should be 2mm higher than the bottom of the overtravel groove, and there should still be an adjustment allowance for the eccentric shaft of the pressure roller after repair. Otherwise, the ring mold should be scrapped